Welcome to the New World of ESP
New Products 3/13/19 Featuring Adafruit#HUZZAH32-#ESP32Breakout Board! @adafruit#adafruit https://www.youtube.com/watch?v=qG0K9noCqZU Pimoroni Inky wHAT (ePaper/eInk/EPD) – Black/White (0:11) https://www.adafruit.com/product/4142 Pimoroni Inky wHAT (ePaper/eInk/EPD) – Red/Black/White (0:11) https://www.adafruit.com/product/4143 Adafruit CharliePlex LED Matrix Bonnet – 8×16 Yellow LEDs (2:05) https://www.adafruit.com/product/4119 Adafruit CharliePlex LED Matrix Bonnet Read More
Arduino Esp32 problems with Hal The beauty of Wifi addressed Esp32, Arduino based, code is that its addressed and they arent based on usb port names that change. Usb devices dont have permanent addresses so its difficult to use more Read More
This took a while to build.
ESP32 Arduino IoT Tutorial on DHT11 Temperature and Humidity Sensor to Cloud in under 10 minutes | iotosphere – Internet of ThingsIn things tutorial we will introduce ESP32, the newest line of ESP modules from expressif systems. I had some Read More
Which One is Preferred to Make a Smart Doorbell – Raspberry Pi or ESP32 Arduino? – The Customize WindowsThe camera modules for boards are not replacement of security systems. Both ESP32 and R Pi has technical limit … https://thecustomizewindows.com/2019/03/which-one-is-preferred-to-make-a-smart-doorbell-raspberry-pi-or-esp32-arduino/ #AbhishekGhosh Read More
Como programar o ESP32 por Wifi usando OTA
ESP32 Arduino and TM1637 Seven Segment LED Display – The Customize WindowsHere are some example working libraries for ESP32’Arduino setup. TM1637’s bad documentation makes it of limited usage… https://thecustomizewindows.com/2019/03/esp32-arduino-and-tm1637-seven-segment-led-display/ #AbhishekGhosh #Arduino #ESP32 #TM1637 #Electronics #Technology
What is LoRa? What Are the Differences Between LoRa and WiFi – The Customize WindowsLoRa is a good way of M2M communication or WAN in the countries where providers of WAN available. Else either cost of own WAN setup is Read More
Amazon FreeRTOSBluetooth Low EnergyEspressif ESP32 | Amazon Web Services
I can’t help but think that 8 bits is all we need to send data for any motion control that we might need for a 3D printer. 6 bits for step/dir, 1 bit to select between two sets of stepper Read More