Was wondering if anyone else has run into this oddity?
I have the NodeMCU connected to the DHT11. All goes fine upload sketch to print temp to serial monitor and it does just that. A funny thing happens when I reset the NodeMCU. When serial monitor starts posting the temp it fails but instead posts NAN.
If I reload the sketch the Temp is posted via serial monitor just fine that is until I reset the NodeMCU.
In order to test possible, bad DHT11 opened up a new one and tried again still same. Then I opened up a new NodeMCU and still the same problem.
Finally used a wemos mini D1 and it had the same problems using the above operation?
Looking for anyone finding this failure and or read a write up on it.